To Clean The Heating Plates; To Clean Resistant, Dried-On Fluids; Storage; Servicing - 3M Ranger 245 Bedienungsanleitung

To clean the heating plates:

The Ranger hardware cleaning tool, is intended to clean both heating plates of the warming unit. It is not necessary to disassemble the warming unit to use the tool.
1. Unplug the irrigation fluid warming unit.
2. Unfold the cleaning tool. Wet the foam pads with a nonabrasive
solution. The following active ingredients are acceptable for use
with the cleaning tool:
• Oxidizers (e.g. 10% Bleach)
• Quaternary Ammonium Compounds (e.g. 3M
Disinfectant Cleaner)
• Phenolics (e.g. 3M™ Phenolic Disinfectant Cleaner)
• Alcohols (e.g. 70% Isopropyl Alcohol)
3. Insert the tool from the back of the unit and pull the tool all the
way out from the front (see Figure 5).
4. Rinse the tool with water and repeat 3 times. Discard the tool
according to institutional protocol.
5. Wipe off the unit to remove excess fluid.

To clean resistant, dried-on fluids:

1. Spray a nonabrasive solution inside the slot of the warming unit and let sit for 15-20 minutes.
2. Clean the unit by using the cleaning tool.
NOTICE
1. To avoid device damage:
• Do not immerse the Ranger unit or accessories in any liquid or subject them to any sterilization process.
• Do not clean the warming unit with solvents. Damage to the case, label, and internal components may result.
• Do not insert metallic instruments in the warming unit.
• Do not use abrasive materials or solutions to clean the heater plates.
• Do not allow spills to dry inside the unit, as this may make it more difficult to clean the unit.
NOTE: You may use a nonmetal instrument, such as a cotton swab, to clean the upper channels. If you are unable to adequately clean the unit, call 3M
technical service.

Storage

Store all components in a cool, dry place when not in use.

Servicing

There are no user-serviceable parts in the Ranger blood/fluid warming unit. All service must be performed by 3M or an authorized service technician. In the
USA, call 3M at 1-800-228-3957 for service information. Outside of the USA contact your local 3M representative.
Please report a serious incident occurring in relation to the device to 3M and the local competent authority (EU) or local regulatory authority.

Symbol Glossary

The following symbols may appear on the product's labeling or exterior packaging.
"OFF" (power)
"ON" (power)
Authorized Representative
in European Community /
European Union
Catalogue number
Caution
CE Mark 2797
Date of manufacture
Quat
TM
To indicate disconnection from the mains, at least for main switches, or their positions, and all those
cases where safety is involved. Source: IEC 60417-5008
To indicate connection to the mains, at least for mains switches, or their positions, and all those cases
where safety is involved. Source: IEC 60417-5007
Indicates the authorized representative in the European Community / European Union. Source: ISO
15223, 5.1.2, 2014/35/EU, and/or 2014/30/EU
Indicates the manufacturer's catalogue number so that the medical device can be identified. Source: ISO
15223, 5.1.6
Indicates that caution is necessary when operating the device or control close to where the symbol
is placed, or that the current situation needs operator awareness or operator action in order to avoid
undesirable consequences. Source: ISO 15223, 5.4.4
Indicates conformity to all applicable European Union Regulations and Directives with notified body
involvement.
Indicates the date when the medical device was manufactured. Source: ISO 15223, 5.1.3
6
Figure 5