H) Mounting The Servo Lever - Reely MISSION Bedienungsanleitung

h) Mounting the servo lever

• After checking or setting the servo neutral position, you can now
mount the servo levers (1) on the throttle and steering servo in such
a way that the rotation path is the same to the left and to the right
and to the front/rear.
Usually this will be the case when the servo lever is at a 90° angle
to the servo (2).
• The steering linkage must be installed so that it moves easily and
without play. It, too, should be positioned in a 90° angle to the servo
lever.
• If the teeth of the servo lever do not allow an exact 90° angle, you
can compensate the tolerance later on when fine-tuning the model
using the trimming.
• The lever on the additional servo must be mounted in such a way that it can rotate from one end position to the other
at the push of a button (see ill. 1, pos. 7) without hitting any mechanical stops.
The illustration 13 shows the linkage of a mechanical drive control (3) as an example.
For more information on the mechanical linkage of a carburettor, refer to section "Adjusting the Gas
Servo". When using an electronic drive control, it will suffice for the time being to set the trimming for the
drive function to 00%.
72
Figure 13