Fine-Tuning The Transmitter - Reely MISSION Bedienungsanleitung



15. Fine-tuning the transmitter

Once you have performed the basic settings and programmed the transmitter, you can now fine-tune your model.
a) Setting of the digital steering trim
Digital trimming enables you to precisely adjust the central position of the steering servo. Thus you can set your model
to drive absolutely straight. To do this, drive your model car on a smooth and even surface and do not make any
steering movements.
• If the model is pulling toward the left, set the adjuster "DT 1" (also see
illustration 1, pos. 15) for digital trimming to the right. Repeat this process
until your model drives straight. If the model is pulling towards the right, you
trim it towards the left.
• Besides the display for the steering servo (TRM-ST) and the two direction
arrows „L.F.U." or „R.B.D.", the display also shows the value of the set trim in
percent.
• Fifteen seconds after the last push of a button, the last set value is saved
and the display switches back to operating display.
After you have determined the required value, keep adjusting the steering linkages until your model drives straight and
the steering trimming value is back to 0O or to a very low value.
Our tip:
Your model car drives perfectly straight when you set a slight toe-in. To do so, adjust the steering link so
that both front wheels steer slightly inward.
102
Figure 52