J) Servo Path Setting For The Brake Function - Reely MISSION Bedienungsanleitung

j) Servo path setting for the brake function

With this function, you can set the servo path for the brake function. You can increase the servo path to increase the
brake effect. If the brake effect is too strong, you can weaken it by reducing the servo path.
By default, the brake path setting is operated with the digital button DT 4. However, if the button is assigned to other
functions, you can also set the brake path setting in the function menu.
Setting the servo path for the brake function
• Switch on the transmitter. On the transmitter's LC display the operating display
will appear.
• Press the SEL button (see ill. 1, pos. 3) nine times to access the menu for
setting the brake servo path.
• Next to the menu display „ATL-BK", the display also shows the default or the
last set value for the brake path function.
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value for the dual rate function between 0% and 100%.
• The smaller the set value, the lower the deflection of the servo when braking.
k) Path setting of the additional servo on channel 3
• The additional servo, which is connected to channel 3 of the receiver,
is operated with the shift key „CH3" (1).
• As it is not possible to perform linear rotating motions with a button,
you fist have to define in how many positions the lever at the addi-
tional servo is supposed to run.
For this purpose, you can select up to 4 different servo positions in
the function menu. For the procedure, turn to the next page.
96
Figure 45
Figure 46