Changing The Crystal; Maintenance And Care - Reely MISSION Bedienungsanleitung



16. Changing the crystal

In order to avoid a double assignment of a channel it may be necessary to change the crystals on your remote control
system.
For reasons of operational safety, you should only use crystals that are explicitly recommended for the
use in your remote control system by the manufacturer.
To change the crystal, proceed as follows:
• With the transmitter turned off, pull the holder for the transmitter
crystal (1) on the back of the transmitter crystal (2) out of the hous-
ing.
• Take the transmitter crystal out of its plastic holder.
• Insert a transmitter crystal (3) with a different channel in the same
frequency band. Please make sure that you place the correct crys-
tal in the holder. Transmitter crystals are normally marked with the
letter T or TX (T = "transmitter").
• Put the crystal holder (1) back into the transmitter.
• Switch the receiver system off and remove the crystal (4) from the
plug-in socket in the receiver.
• The suitable crystal for the receiver has to be marked with the same
channel number as the transmitter crystal. In addition it is marked
with the code R or RX (R = receiver).
• Insert the receiver crystal (5) with the suitable frequency for the trans-
mitter into the receiver.
• Switch on the transmitter and afterwards the receiver and check the
functioning of the system.


17. Maintenance and care

Clean the exterior of the remote control only with a clean, soft, dry cloth. Never use aggressive cleansing agents or
chemical solutions, because they might damage the surface of the housing.
Remove dust with a soft, clean brush.
Figure 54
105