Reely MISSION Bedienungsanleitung Seite 169

Setting the guidance and return speed
• Switch on the transmitter. On the transmitter's LC display the operating display
will appear.
• Press the SEL button (see ill. 1, pos. 3) twice times to access the menu for
setting the speed of the steering servo.
• Next to the menu display „SPD-TN", the display also shows the default or
the last set value for the steering speed.
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value for the guidance speed between 0 and 100.
The lower the set value, the higher the delay or the slower the steering servo
runs. There is no delay at a value of 100.
• Then press the CH button (see ill. 1, pos. 5).
The display shows the menu "SPD-RN" and the default or the last set value
for the return steering speed.
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value for the return speed.
The limitation of the steering in and steering out speed only takes effect if the steering wheel is moved
faster than the respectively set value. Slower steering motions are transmitted 1:1 to the steering servo.
Figure 30
87