H) Digital Trimming - Reely MISSION Bedienungsanleitung

h) Digital trimming

With the digital trimming function, you can set the central position of the drive and steering servo individually.
A model vehicle that slightly pulls to the left during driving can be adjusted to the right with the trim function so that it
runs absolutely straight if the steering wheel on the transmitter is in central position.
During the warming-up phase of the combustion engine, it can be e.g. set to a higher idle phase with the throttle trim
to prevent the motor from stalling when braking.
By default, the steering and drive trim can be operated with the digital buttons „DT 1" and „DT 2".
However, if the buttons are assigned to other functions, you can also set the digital trim in the function menu.
Setting of the steering and throttle trim
• Switch on the transmitter. On the transmitter's LC display the operating display
will appear.
• Press the SEL button (see ill. 1, pos. 3) seven times to access the menu for
setting the throttle/brake trim.
• Next to the menu display „TRM-ST", the display also shows the default or
the last set value for the steering trim.
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value for the steering trim between L 100 and R 100.
• Then press the CH button (see ill. 1, pos. 5).
• The display shows the menu "TRM-TH" and the default or the last set value
for the throttle trim.
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value between F 100 (forward) and F 100 (backward).
94
Figure 42