Switching On The Transmitter - Reely MISSION Bedienungsanleitung

Warning!
Connect the charger only if the rechargeable batteries (1.2V/cell) have been inserted in the transmitter.
Never try to recharge batteries (1.5V/cells) with a charger. There is a risk of fire and explosion!
In order to avoid damages to the internal circuit paths and connections, please don't use fast chargers.
c) Switching on the transmitter
• When the rechargeable batteries are charged or when new batteries are
inserted, pull out the antenna of the transmitter all the way and, for test
purposes, switch the transmitter on via the function switch (see figure 1, Pos.
13).
To do so, slide the control button from the bottom to the top (slanted). The
red battery control LED (see figure 1, pos. 9) lights up briefly and a short
beep tone signals adequate power supply of the transmitter.
Parallel to this, the nodulation type (PP) for PPM modulation appears briefly
on the LC display next to the model name (M01) and the model memory (01)
before the current operating voltage is displayed.
• If the voltage supply falls below 8.5 V, the display shows "Err" (for "Error")
and "Low BT" (for "Low Battery").
At the same time, the remote control sensor emits three short signals as an
acoustic alarm at regular intervals.
In this case, you should stop operating your model as quickly as possible.
For further operation of the transmitter the rechargeable batteries have to be
recharged or new batteries have to be inserted. To prevent this scenario, you
should stop operating your transmitter when the supply voltage drops to
9.0 V.
In order to avoid the memory effect of NiCd rechargeable batteries, you should connect the charger
only when the rechargeable batteries are completely discharged.
66
Figure 4
Figure 5