Checking The Control Functions - Reely MISSION Bedienungsanleitung

d) Checking the control functions
• Connect the servos or drive controls used in your model and the
power supply to the receiver.
• Next, switch on the transmitter and then the receiver. If you have
connected everything correctly, the steering should respond to
turning movements of the steering wheel (see illustration 01, pos.
6) and the drive of the model to the operating lever for the drive
function (see illustration 01, pos. 7).
• If the steering or drive function respond with movements exactly
opposite to the steering direction on the transmitter, this can be easily
reprogrammed.
For the exact procedure, refer to the following section „Programming
the remote control", point „Setting the servo rotation direction".
The mini truck shown in the illustration merely serves to better illustrate the steering function and is not
included in the scope of delivery of the remote control.
Warning!
If the operating button for channel 3 „CH 3" (see ill. 9, pos. 1) is pressed, it may happen that the servo
connected to the receiver output 3 does not perform any motions yet. In this case, program the respective
positions in which the servo is supposed to run in the transmitter. Further information is contained in the
chapter: „Path setting of the additional servo on channel 3".
Figure 9
69