Getting Started With The Transmitter; A) Inserting The Batteries/Rechargeable Batteries; B) Loading The Rechargeable Batteries For Transmitter - Reely MISSION Bedienungsanleitung



10. Getting started with the transmitter

In the operating instructions, the numbers in the text always refer to the figure opposite or the figures
within the section. Cross references to other figures are indicated with the respective figure number.

a) Inserting the batteries/rechargeable batteries

The power supply of the transmitter requires 8 alkaline batteries (e.g. Conrad item no.: 652507, pack of 4, order 2 x) or
accumulators size Mignon (AA). For ecological and also for economical reasons it is recommended to use rechargeable
batteries, since they can be recharged in the transmitter via a built-in charging socket.
To insert the batteries or rechargeable batteries, proceed as follows:
• The battery compartment lid (1) is located on the bottom of the
transmitter. Please press the corrugated triangle (2) and push off
the cover sideways to the left.
• Now insert the eight batteries or rechargeable batteries in the battery
compartment. Pay attention to the correct polarity of the cells. The
negative pole (housing) of the battery or rechargeable battery must
have contact with the spiral spring.
A corresponding notice (3) is located on the bottom of the battery
compartment. Please note that the 4 batteries/accumulators on the
right have to be slid underneath the peg (4) first before inserting the
other 4 batteries/accumulators.
• Afterwards slide the lid of the battery compartment back on and let
the locking mechanism click into place.
b) Loading the rechargeable batteries for the transmitter
• During the operation with rechargeable batteries you can connect a
charging cable to the charging socket (1) and charge the
rechargeable batteries in the transmitter when the transmitter is
switched off. It is very important that you pay attention to the correct
polarity of the connector plug.
The inner contact of the charge socket has to be connected to the
plus connection (+) and the outside contact to the minus connection
(-) of the charger.
• The charging current should be approx. 1/10 of the capacity value
of the inserted rechargeable batteries. For rechargeable batteries
with a capacity of 2000 mAh this corresponds to a charging current
of approx. 200 mA and charging time takes approx. 14 h.
Since a protective diode is integrated in the transmitter, no chargers can be used that briefly interrupt
the charging current in order to measure the current rechargeable battery voltage. In this case, the
rechargeable batteries must be removed from the transmitter.
Figure 2
Figure 3
65