Reely MISSION Bedienungsanleitung Seite 172

ABS delay = ABS-DL
In this menu point, you can set the time after which the ABS function is to kick in. The value range is between 0 and
100. A value of 50 corresponds to a time unit of 0.7 seconds and the value 100 to a time value of 1.7 seconds.
Setting ABS function
• Switch on the transmitter. On the transmitter's LC display the operating display
will appear.
• Press the SEL button (see ill. 1, pos. 3) four times to access the menu for
setting the ABS function.
• Next to the menu display „ABS-PT", the display also shows the default or the
last set value for the brake reset.
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value between 0 and 100.
If you press and hold the plus and minus buttons (see ill. 1, pos.
4) at the same time, the default value of 50 is restored
automatically.
• Then press the CH button (see ill. 1, pos. 5).
• The display shows the menu "ABS-CY" and the default or the last set value
for the brake cycles.
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value between 1 and 30.
If you press and hold the plus and minus buttons (see ill. 1, pos.
4) for 1 second at the same time, the default value of 10 is
restored automatically.
90
Figure 34
Figure 35