E) Checking And Setting The Neutral Servo Settings - Reely MISSION Bedienungsanleitung

e) Checking and setting the neutral servo settings

Prior to programming the remote control system or adjusting your model, you have to make sue that the digital trimming
for the steering and drive function is in the central position (value 00%).
Each brief push of the programming and setup buttons is confirmed with an acoustic signal. If a button
is pressed longer, the remote control transmitter issues a fast sequence of beeps.
• With the setup button „DT 1" (see ill. 1, pos. 15), you set the central position
for the steering servo (CH 1).
• If you briefly press the button, the display switches from the operating display
to the trim display.
• With each further press of the button, the trim value in percent is changed by
1%. By pressing the button in both directions, you can increase or decrease
the value. If the button is pressed and held, the setting value changes
continuously (quick adjustment).
The exact central position is reached once the display reads exactly 00%.
• If the button „DT 1" is not pressed for approx. 15 seconds, the last set value
is saved and the display switches back to the operating display.
• With the setup button „DT 2" (see ill. 1, pos. 2), the central position of the
throttle/servo/drive control (CH 2) is adjusted according to the same scheme
as the steering servo.
• Now check the trimming of both channels and set the values to
exactly 0%.
70
Figure 10