Setting The Model Name; E) Display Of The Impulse Modulation Type - Reely MISSION Bedienungsanleitung

d) Setting the model name
In addition to the memory numbers 01 - 10, you can assign a short name consisting of three letters, digits or characters
to each model.
If you wish to enter the model name, proceed as follows:
• Call up the setup menu and press the SEL button (see ill. 1, pos. 3) three
times to access the menu for setting the model name.
The display briefly shows "NAM", before displaying the setup mode.
• The first three letters of the name blink on the setup display, which can now
be changed using the plus and minus buttons (see ill. 1, pos. 4). The sequence
comprises the letters of the alphabet, the numbers 0 – 9, and some special
characters.
• When the first letter is assigned, you can select the second letter with the CH
button (see illustration 1, pos. 5) and set it according to the same procedure.
Afterwards you press the CH button again to get to the third letter.
• If need be, press the CH key again to be able to change the first letter again.

e) Display of the impulse modulation type

• Call up the setup menu and press the SEL button (see ill. 1, pos. 3) four
times to access the modulation type menu.
As the transmitter as well as the receiver only work with PPM
modulation, it is not possible to switch to a different modulation
type in this menu.
Figure 19
Figure 20
77