Final Assembly Of The Model Aircraft; Mounting The Tail Fins; Mounting The Undercarriage - Reely Jet Gyro Bedienungsanleitung

9. Final assembly of the model aircraft

Before starting with the assembly of the model, prepare an appropriate surface. In order to achieve excel-
lent flight performance, your model is manufactured with a light moulded foam. This material has a sensi-
tive surface. Even minor carelessness during assembly of the model may very quickly result in ugly dents
or scratches.
a) Mounting the tail fins
Place the tail fins (1) on the guide rails so that the two
hooks (2) engage in the openings (3).
Then push each tail unit forward in the direction of flight
so that the locking latches on the hooks lock the tail unit
in place.
Then check the alignment of the tail fins. There should be
the same distance between the tips of the tail fins and the
tailplane (sections A1 and A2).
b) Mounting the undercarriage
The model can be equipped with a nose undercarriage (1)
and a main undercarriage (2) for take-off and landing on a
smooth and level surface. For this purpose, the undercar-
riage wires are inserted into the prepared undercarriage
mounts (3) on the underside of the fuselage.
Since the undercarriage wires are held in place by spring
force, no extra securing is required. In addition, the under-
carriage can be easily attached and detached at all times.
It is advisable not to use the undercarriage when operating
the model on a lawn or meadow. In this case, the model is
launched by hand and belly landed on the grass.
40
Figure 3
Figure 4