Reely MISSION Bedienungsanleitung Seite 180

Setting the servo positions
• Switch on the transmitter. On the transmitter's LC display the operating display
will appear.
• Press the shift button „CH3" (see ill. 46, pos. 1) until the display shows
„CH3-P1".
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value between -100% and +100%.
At 0%, the server is later on in the central positions and at -100% and +100%,
the max. possible servo deflection is achieved.
• Press the shift button „CH3" (see ill. 46, pos. 1) to switch the display to
„CH3-P2".
Then set the required value for the second servo position with the plus and
minus buttons.
• Repeat this process until you have assigned the right value to all defined
servo positions.
98
Figure 48