Commissioning The Receiver; Receiver Connection - Reely MISSION Bedienungsanleitung



11. Commissioning the Receiver

a) Receiver connection
• The receiver allows you to connect up to 3 servos (receiver output
1, 2 and 3) and a receiver accumulator (receiver connection B),
which are equipped with Futaba connectors (with reverse polarity
protection).
• As an alternative, you can also use servos/controls with J/R
connectors.
• When connecting servos and drive controls, always make sure to pay
close attention to the correct polarity of the plug connectors. The wrap
connection for the positive lead (yellow, white or orange, depending
on the manufacturer) must be connected to the inner pin contact. The
wrap connection for the negative lead (black or brown, depending on
the manufacturer) must be connected to the outer pin contact.
Warning!
If the operating button for channel 3 „CH 3" (1) is pressed, it may happen that the servo connected to
the receiver output 3 does not perform any motions yet. In this case, program the respective positions
in which the servo is supposed to run in the transmitter. Further information is contained in the chapter:
„Path setting of the additional servo on channel 3".
Depending on the model for which you use the remote control system, the connection as well as the power supply of
the receiver and the servos can be effected in different ways:
Receiver Combustion model (A)
Connection with mechanic
Drive control (A)
1 steering servo
2 throttle servos
3 additional servos*
BATT Battery box/
rech. battery
Figure 7
Electric car model Electric car model
with electronic with drive control (A/B)
drive control (B)
Steering servo Steering servo
Drive control servo Cruise Control
Additional servo* Additional servo*
Battery box/ ***
rech. battery **
Figure 6
Ship model
Rudder servo
Drive control (servo)
Additional servo*
Battery box/
rech. battery **/***
67