Reely MISSION Bedienungsanleitung Seite 181

I) The servo central adjustment
When installing the servos, the model manufacturer usually describes the exact central position for the servo levers.
However, the cogs on the servo lever may not always allow the exact positioning of the servo lever if the operating
levers and the corresponding trim are in central position at the transmitter.
With the help of the servo center shift (subtrim function), you can remedy this and still have the full trim function
available on both sides.
The central servo position can be set separately for each of the 3 control channels.
Setting the servo central position
• Switch on the transmitter. On the transmitter's LC display the operating display
will appear.
• Press the SEL button (see ill. 1, pos. 3) eleven times to access the menu for
setting the central servo position.
• Next to the menu display „SB-ST", the display also shows the default or the
last set value for the steering trim.
• With the plus and minus buttons (see illustration 1, pos. 4) you can now set
the desired value for the guidance speed.
• Then press the CH button (see ill. 1, pos. 5).
• The display shows the menu "SBT-TH" and the default or the last set value
for the throttle trim.
• The setting with the plus and minus buttons (see ill. 1, pos. 4) takes place
according to the same scheme as the steering servo.
• Press the button CH again (see ill. 1, pos. 5) to also set the central position
exactly at the additional servo on channel 3 with the plus and minus buttons.
Figure 49
99