Reely MISSION Bedienungsanleitung Seite 179

Setting the number of servo positions
• Switch on the transmitter. On the transmitter's LC display the operating display
will appear.
• Press the SEL button (see ill. 1, pos. 3) ten times to access the menu for
setting servo positions.
• Next to the menu display „CH3-1P", the display also shows the default or the
last set value for the servo position.
• With the CH button (see ill. 1, pos. 5), you can now set in how many positions
the additional servo is supposed to run.
With each press of the button, the display is increased by one servo position
(P1 ... P4).
In position P5, the servo later on runs from one to the next stop when operating
the button CH3.
Once you have set the number of different servo positions, you
have to set the exact position (angle position of the servo lever),
see next paragraph.
Figure 47
97