B) Copying The Model Memory; C) Deleting The Model Memory - Reely MISSION Bedienungsanleitung

b) Copying the model memory

Your remote control system provides a total of ten different model memories (M01...M10) in which you can store the
individual settings for ten different models. Alternatively, you can also set different values for one model and then save
them separately.
To simplify the programming of a model memory, you can copy the data from the currently used model memory to
another model memory.
For this purpose, proceed as follows:
• Call up the setup menu and press the SEL button (see ill. 1, pos. 3) once to
access the copy function.
On the left of the LC display, you see the current model memory that can be
copied.
If you want to copy a different a different model memory, you
first have to call up the desired memory in the function menu.
• Press the CH button (see ill. 1, pos. 5) as long as the desired target memory
appears on the right of the display.
• Now press the plus and minus buttons (see ill. 1, pos. 4) together at least 1
second to start the copy process.
• The display signals „OK" to indicate the end of the copy process.

c) Deleting the model memory

With the help of this function, you can delete the data in the currently used model memory or reset them to the default
settings.
For this purpose, proceed as follows:
• Call up the setup menu and press the SEL button (see ill. 1, pos. 3) twice to
access the menu for deleting the model data.
You can only delete the currently active model memory. If you
want to delete a different a different model memory, you first
have to call up the desired memory in the function menu.
• Now press the plus and minus buttons (see ill. 1, pos. 4) together at least 1
second to start the delete process.
• The display signals „OK" to indicate the end of the copy process.
76
Figure 17
Figure 18