M) Setting The Servo Rotation Direction (Rev) - Reely MISSION Bedienungsanleitung

m) Setting the servo rotation direction (REV)

Depending on the installation position and steering in the model, it might be required to change the rotation direction
of a servo.
When you turn the steering wheel on the transmitter (see illustration 01, pos. 6) to the left, but the vehicle steers to the
right, you must activate the Reverse function for channel 1 (ST).
Changing the servo rotation direction
• Switch on the transmitter. On the transmitter's LC display the operating display
will appear.
• Press the SEL button (see ill. 1, pos. 3) eleven times to access the menu for
setting the servo rotation direction.
• Next to the menu display „REV-ST", the display also shows the default or the
last set value for switching the rotation direction of the steering servo.
• With the help of the plus and minus buttons (see ill. 1, pos. 4), you can now
change the rotation direction of the servo. The top of the display indicates
whether the rotation direction reverse is activated or deactivated.
• Then press the CH button (see ill. 1, pos. 5).
• The display shows „REV-TH", and the default or the last set value for switching
the rotation of the throttle servo.
• Switching with the plus and minus buttons (see ill. 1, pos. 4) takes place
according to the same scheme as with the steering servo.
• Press the button CH again (see ill. 1, pos. 5) to also set the rotation direction
on the additional servo with the plus and minus buttons.
100
Figure 50