Weber Alpha Entry Originalbetriebsanleitung Seite 129

Chapter 7 Operation
LABEL COUNTER: (LBL COUNTER)
Here, you are provided with the opportunity to specify a certain value between 0-99999 for
the label counter. With the input of a value greater than "00000", you also activate the count-
down function. This means, that the entered value will be counted down during the labeling
operation at each application cycle. The display will then show a "minus" before the counter
value. The counter value is equivalent to the remaining application cycles. Upon reaching the
end value "-0000", the labeler will automatically stop.

Press the buttons [] or [] to go to the next parameter.

Press [Enter] to edit the front digits.

Afterwards, press the [] or [] * buttons to increase / decrease the value of the
parameter to be edited (the respective cursor will blink).

Press [Enter] again to switch to the rear digits or exit editing mode.

To exit the parameter settings please press [Start] or [Stop] respectively.
RESET LABEL COUNTER (RST LABEL COUNT)
This function resets the counter value of the label counter.

Press the [] or [] * buttons to switch to the next parameter.

Press [Enter] to reset the counter to "0000".

To exit the parameter settings please press [Start] or [Stop] respectively.
Version: 23.04.2018
*Fast forward function when the [] or [] button is held down.
Page 51 of 76
40059377 BTA Alpha Entry
ML-GB
DE
GB
FR
ES
RU