Installation; Requirements At The Site Of Installation - Weber Alpha Entry Originalbetriebsanleitung

Chapter 6 Installation and initial commissioning

Installation

Only an optimally aligned system installation is able to ensure trouble-free continuous opera-
tion with minimal wear. For optimal system installation, it is essential to carry out fine-tuning
that is adapted to the application conditions. Fine-tuning requires extensive expertise which
is primarily founded on experience gained from working with labeling technology.
This specific technical knowledge cannot be completely conveyed via the operating instruc-
tions. The labeler must therefore be installed by a technician of the Bluhm Weber Group or
tested and approved in a final inspection. Damage or consequential damage which is at-
tributable to improper installation without the necessary fine-tuning, shall not be covered by
the warranty.

Requirements at the site of installation


Closed and clean room.

Flat, solid base, roughness may not exceed 5 mm when using stands from the Weber
Group.

Sufficient floor load-bearing capacity.

Low-vibration environment.

Adequate lighting: 500 Lx.

No direct irradiation by sunlight or radiators.

The machine may not be operated in the vicinity of electrostatic or magnetic fields. This
can cause controller faults.

Correct energy supply (electricity, compressed air if necessary) according to the chap-
ter "Technical specifications".
Positioning of the labeler

The labeler and peeler plate must not come into contact with the product (distance 2-3
mm).

The peeler plate should be positioned at an angle of approximately 15° in relation to
the product surface.

The installation location must allow sufficient access for the operators and service
technicians. Especially the power switch/plug to disconnect the mains voltage must be
easily accessible.

Make sure that all fasteners are sufficiently tightly secured.

Observe all the points of the "intended use" in the "Safety Regulations" chapter.
Version: 23.04.2018
There is a risk of injury on edges and corners.
RISK OF INJURY!
Sharp edges and sharp corners can cause abrasions and cuts to
the skin.
̶ Caution when working in the vicinity of sharp edges and sharp
corners. Remove any items which are not required.
̶ In case of doubt wear protective gloves.
Page 27 of 76
40059377 BTA Alpha Entry
ML-GB
DE
GB
FR
ES
RU