Yamaha E60HMHD Wartungshandbuch Seite 126

CONTROL SYSTEM
ADJUSTING THE THROTTLE LINK
CAUTION
Do not adjust the throttle link when it is
operating properly. Excessive adjustment
may cause the engine poor perfomance.
1. Check:
• Ignition timing
• Magneto control lever operation
Incorrect
Checking steps:
(1) Turn the magneto control lever 1 until
it contacts the crankcase surface
(2) Check the magneto control lever 2 so
that it contacts the full retard stopper
3.
2. Adjust:
• Throttle link
Adjusting steps:
(1) Disconnect the link joint 4 from the
magneto control levers 1 and 2.
(2) Turn the magneto control lever 1 until
it contacts the crankcase surface
(3) Set the magneto control lever 2 to
fully retard, it contacts the full retard
stopper 3.
(4) Adjust the length
untill the holes align with the pins on
magneto control levers 1 and 2.
(5) Install the link joint 4.
3-11
Adjust.
b
of the link joint 4
E
a
.
a
.