After Washing - MOTO GUZZI V11 SPORT Werkstatt-Handbuch

A
B
C
D
E
F
G
H
I
L
M
N
O
P
18
9 CLEANING THE MOTORBIKE
P
REPARATION FOR WASHING
Before washing the vehicle, it is necessary to cover the
following parts with nylon sheets:
• Exhaust silencer terminal parts;
• Clutch and brake levers;
• Gas control;
• LH light control device,
• RH ignition device;
• Starter switch;
• Shaft with transmission unions;
• ECU.
N.B.
The Electronic Control Unit is located under the
saddle.
W :
HILE WASHING
Avoid spraying the instruments and the rear and front hub
with high pressure water.
WARNING
Do not wash the unions with high pressure water
or solvents.
A :
FTER WASHING
Remove all the nylon covers.
Thoroughly dry all the vehicle.
Try the brakes before using the vehicle.
N.B.
To clean the propulsor unit's painted parts
(engine, gearbox, transmission box etc.) the
following products should be used:
- Petroleum naphtha
- Diesel oil
- Oil
- Water-based neutral detergents for cars
C U
ONTROL AND
:
M
SE OF THE ORBIKE