MOTO GUZZI V11 SPORT Werkstatt-Handbuch Seite 304

A
A
B
C
D
E
F
G
D
GRADING CYLINDER DIAMETER SINCE ENGINE N° KR 014485
H
GRADE A
92,000÷92,006
I
GRADING PISTON DIAMETER SINCE ENGINE N° KR 014485
L GRADE A
91,954÷91,960
M
Ø 92.000 ÷ 92.018
N
O
P
46
C
GRADE B GRADE C
92,006÷92,012 92,012÷92,018
GRADE B
GRADE C
91,960÷91,966 91,966÷91,972
1st Measurement
1. Messung
a
1 Meting
2nd Measurement
2. Messung
a
2 Meting
3rd Measurement
3. Messung
a
3 Meting
5 CYLINDERS AND PISTONS
N.B.
The procedures described below refer to the
disassembly of only one head, but they are valid
for both.
Disassembly:
• Remove the engine unit, as described in chapter 2 in
this section;
• Remove the head, as described in chapter 4 in this
section;
• Remove cylinder "A" from the stud bolts;
• Remove the clamps "B" for the piston pin "C";
• Remove the piston pin "C" using the special tool,
commercially available;
• Remove the piston "D";
C
HECK OF COMPONENTS
B
Cylinder wear control:
The cylinders' diameter must be measured at three heights,
turning the dial gauge by 90°.
Check that the cylinders and pistons belong to the same
selection category (A,B,C).
GRADING CYLINDER DIAMETER UP TO ENGINE N° KR014486
GRADE D
92,000÷92,010
GRADING PISTON DIAMETER UP TO ENGINE N° KR014486
GRADE D
91,942÷91,952
checking measure
for selection
Kontrollmaß
für die Auswahl
controlemaat
voor selectie
GRADE E GRADE F
92,010÷92,020 92,020÷92,030
GRADE E
GRADE F
91,952÷91,962 91,962÷91,972
91.954 ÷ 91.972
E
NGINE