Cleaning The Motorbike; After Washing - MOTO GUZZI CALIFORNIA JACKAL Werkstatt-Handbuch

A
B
C
D
E
F
G
H
I
L
M
N
O
P
18
9

CLEANING THE MOTORBIKE

P
REPARATION FOR WASHING
Before washing the vehicle, it is necessary to cover the
following parts with nylon sheets:
• Exhaust silencer terminal parts;
• Clutch and brake levers;
• Gas control;
• LH light control device,
• RH ignition device;
• Starter switch;
• Shaft with transmission unions;
• ECU.
N.B. The ECU is placed under the left side body
panel; it is placed under the passenger's seat
only on California EV 1
W :
HILE WASHING
Avoid spraying the instruments and the rear and front
hub with high pressure water.
A :
FTER WASHING
Remove all the nylon covers.
Thoroughly dry all the vehicle.
Try the brakes before using the vehicle.
N.B.
To clean the propulsor unit's painted parts
(engine, gearbox, transmission box etc.) the
following products should be used:
- Petroleum naphtha
- Diesel oil
- Oil
- Water-based neutral detergents for cars
C U
ONTROL AND
:
st series.
M
SE OF THE ORBIKE