MOTO GUZZI V11 SPORT Werkstatt-Handbuch Seite 104

A
B
C
D
E
F
G
H
I
L
M
N
O
P
44
B
Every 2000 mi check for the thickness of the brake pads:
• The minimum thickness of friction material is 1.5 mm.
If the minimum thickness of the friction material is less
than this value, it is necessary to replace the pads.
After replacement, it is not necessary to drain the braking
system. Just activate the control lever repeatedly until
the caliper pistons are brought to the normal position once
again.
When replaceing the pads, check the condition of the
flexible tubings; they must be replaced immediately if
damaged.
The motorbike is equipped with calipers which allow the
pads to be replaced without having to be removed from
their respective supports.
F
B
D
C
• Remove the 2 flexible split pins "A";
• Remove the 2 pins "B";
• Remove the external shield "C";
A
• Remove the 2 pads "D", if the pads are worn beyond
B
Reassembly:
• Fit the 2 pads into the caliper;
• Place the external shield in its position;
• Insert the pins, pads and external shield into their seats
• Insert the flexible split pins into the pins.
D
/
RAKE PAD CHECK REPLACEMENT
N.B.
After the pads have been replaced, it is necessary
to use the brakes with moderation for the first
100 Km in order to allow them to bed-in correctly.
RONT BRAKE CALIPER
assembly:
IS
the prescribed limit they must be replaced with new
ones;
on the calipers;
S
CHEDULED
M
AINTENANCE