MOTO GUZZI V11 SPORT Werkstatt-Handbuch Seite 126

A
B
C
D
E
F
G
H
I
L
M
N
O
P
6
Removal 2:
• Place a support under the motorbike so you can lift
the front wheel from the ground;
• Remove the calipers as described for fastening 1;
• Loosen the 2 screws fastening the spindle to the fork
struts;
• Unscrew the spindle and remove the wheel.
For information on overhauling, see chapter 3 in this section.
Reassembly 2:
After having carried out all the necessary tests on the
wheel, reassemble in the following way:
• Insert the complete wheel between the fork struts;
• Lubricate the wheel spindle shaft and threading with
recommended grease;
• Grease the threading on the LH strut;
• Screw down the wheel spindle;
• Tighten the 2 screws fastening the spindle to the strut
to the prescribed torque.
• Refit the brake calipers by tightening the fastening
screws to the prescribed torque;
• Check that the disks move freely inside the calipers
and then repeatedly activate the brake lever to restore
the normal position of the caliper pistons.
W
HEEL PARTS