MOTO GUZZI V11 SPORT Werkstatt-Handbuch Seite 98

A
B
C
C
D
E
F
G
H
I
L
M
N
O
P
38
D
A
F
• Turn the handlebar until the tank is in a horizontal
• Fill the tank if necessary
• Remove the rubber cover from the draining union "A"
• Immerse the free end of the tube in a transparent
• Loosen the draining union "A";
• Fully pull the control lever on the handlebar, then release
B
• Repeat this procedure until fluid, without air bubbles,
• Keep the control lever fully pulled and lock the draining
• Refit the rubber cover onto the union.
If the draining procedure has been effected correctly, a
direct fluid action, without elasticity, should be noticed
immediately after the control lever's initial stroke.
If this is not the case, repeat the above described
procedures.
RAINING THE BRAKING SYSTEM FLUID
RONT BRAKING SYSTEM
position;
and insert a transparent flexible tube into the union
"B";
container "C" filled with the same type of liquid;
it and wait some seconds before pumping again.
comes out from the tube in the transparent container;
union "A" to the torque prescribed in the table, chapter
4, section B ;
WARNING
During the draining procedure, make sure that
the fluid does not drop below the minimum level.
S
CHEDULED
M
AINTENANCE