MOTO GUZZI V11 SPORT Werkstatt-Handbuch Seite 260

A
B
C
D
E
F
G
H
I
L
M
B
N
O
P
2
A
1 GENERAL RULES
OVERHAUL
During fitting, take the engine weight and center of gravity
into account; support it accordingly.
Take care of any dangerous points which may cause
squeezing or cuts.
Engine and system maintenance involve a specific and
acquired know-how as well as the use of special tools.
All maintenance and repair procedures can be carried out
by specifically trained technicians only.
IMPORTANT
Observe the instructions supplied by the vehicle
manufacturer.
2 ENGINE UNIT REMOVAL -
INSTALLATION
Removal:
To remove the engine unit from the motorbike, the following
components must be disassembled:
• Tank as described in chapter 3 section I;
• 1Air filter box as described in chapter 8 section I;
• Exhaust system section L;
• Side stand as shown in chapter 4 section H;
• Starter motor as described in chapter 3 section P;
• Steering shock absorber as described in chapter 9
section F;
• Oil radiator as shown in chapter 3 of this section;
After having removed the above mentioned parts, proceed
as follows:
• Detach connector "A" for the oil temperature sensor,
found on the RH side of the motorbike;
• Disconnect the two wires "B" for the alternator;
E
FOR ENGINE
NGINE