MOTO GUZZI V11 SPORT Werkstatt-Handbuch Seite 100

A
B
C
D
E
F
G
H
I
L
M
N
O
P
40
A
B
C
R
EAR BRAKING SYSTEM
• Fill the tank if necessary;
• Remove the rubber cover from the draining union "A"
and insert a flexible trasparent tube "B" into the union;
• Immerse the free end of the tube in a transparent
container "C" filled with the same type of fluid;
• Loosen the draining union "A";
• Press down completely the control pedal, then release
it and wait some seconds before pumping once again.
• Repeat this procedure until fluid, without air bubbles,
comes out from the tube in the transparent container;
• Keep the pedal pressed down completely and tighten
the draining union "A" to the torque prescribed in the
table, chapter 4, section B;
• Refit the rubber cover onto the draining union.
If the draining procedure has been effected correctly, a
direct fluid action, without elasticity, should be noticed
immediately after the control lever's initial stroke.
If this is not the case, repeat the above described proce-
dure.
WARNING
During the draining procedure, make sure that
the fluid does not drop below the minimum level.
S
CHEDULED
M
AINTENANCE