MOTO GUZZI V11 SPORT Werkstatt-Handbuch Seite 222

A
B
A
C
B
D
Air gap
E
Spalt
Luchtspleet
F
G
H
SPACERS AVAILABLE IN mm:
VERFÜGBARE SCHEIBEN IN mm:
SPIEËN BESCHIKBAAR IN mm:
mm CODE
mm KENNUMMER
mm CODE
I
0,3 01 72 27 00
0,4
01 72 27 01
0,5 29 72 27 60
L
0,6 01 72 27 02
M
N
O
P
30
Fit adjusting shims to obtain an
air gap of 0.7÷0.9
Die Anpassungsscheiben einfügen, um
einen Spalt von 0,7÷0,9 herzustellen
Spieën van bijregeling invoeren om een
luchtspleet van 0,7÷0,9 te bekomen.
mm CODE
mm KENNUMMER
mm CODE
01 72 27 03
0,8
1 01 72 27 04
1,5 01 72 27 05
16 R.P.M. AND T.D.C. SENSOR "7"
The sensor reads the signal from a toothed wheel fitted
on the camshaft.
The information about the r.p.m and the camshaft position
is obtained from the frequency of this signal. This allows
the position of the various cylinders with respect to their
explosion T.D.C. to be detected.
Disassembly:
• Unscrew the two screws "A" fastening it to the engine;
• Remove the sensor "B" disconnecting the cable from
the wiring.
N.B.
The sensor gasket is supplied in various
thicknesses for adjustment.
Refer to the table on the side for the order code.
F
UEL SYSTEM