Changing The Crystal; B) Change Of Crystal - Reely 23 52 11 Bedienungsanleitung

b) Changing the crystal
There may be no other transmitter/models with the same frequency in the range of the transmitter, as these transmitters
interfere with each other. As a result, the models no longer respond correctly to the transmitter commands. If there are
other model vehicles in your range, talk to the other operators about the frequencies they use.
For reasons of operational safety, you should only use crystals that are explicitly recommended for the
use of your remote control system by the supplier.
• Prior to a quartz change, first turn off the vehicle and then the transmitter.
• Pull the holder of the transmitter crystal out of the transmitter casing (see figure 1, pos. 6).
• Take the transmitter crystal out of its plastic holder. Insert the replacement crystal with a different channel in the
same frequency band.
Please make sure that you place the right crystal in the holder. Transmitter crystals are normally marked with the
letter T or TX (T = "transmitter").
• Put the crystal holder back into the transmitter.
• Pull the receiver quartz out of the vehicle's receiver when the drive accumulator is disconnected.
• The suitable replacement crystal for the receiver has to be marked with the same channel name as the transmitter
crystal. In addition it has the letter code R or RX (R = receiver) on it.
• Insert the replacement crystal with the suitable frequency for the transmitter into the receiver.
• Switch on the transmitter and afterwards the receiver and check the function of the system.
38