Checking The Control Functions - Reely Sparrow Bedienungsanleitung

15. Checking the Control Functions

Before starting your model for the first time, you need to familiarise yourself with the control functions and test the
model functions.
Switch on the transmitter first and connect the flight battery to the model.
Motor Function
Attention!
Ensure that no loose parts, such as paper, film or other objects can be sucked into the rotor during this motor
test. Also make sure that the model is held securely during this test run and that no clothing and body parts
are within the rotation range or danger area of the rotor.
• Slide the control lever for the engine speed (also see figure 1, item 4 or 12, depending on mode set) to the bottom
position (engine off).
• Start up the transmitter and then the model (connect rechargeable battery).
• Push the control lever for the motor function slowly from the bottom to the top position. The rotor will start up and
increase speed depending on control lever position.
• When the control lever is at the top stop, the maximum rotor speed is reached. Then move the control lever back to
the bottom-most position.
• Perform a brief motor test and check the run of the rotor.
• For the following tests, observe that the motor is deactivated. Slide the control lever for the engine speed (also see
figure 1, item 4 or 12, depending on mode set) to the bottom position (engine off).
• Disconnect the flight battery from the model again and switch off the transmitter.
Neutral Position
When the control lever for the rudder and elevator function and the digital trimming of the control functions is precisely
in the centre position, the rudder (figure 10, item 1) and elevator (2) should be precisely at the centre as well. Viewed
from the rear, the rudders and elevators must form a level with the rudder and must not be deflected to the top or
bottom, left or right.
44
Figure 10