Checking The Remote Control Functions; Adjusting The Transmitter Trim; Checking The Neutral Position Of The Rudders - Reely Mini Hawk Bedienungsanleitung

11. Checking the remote control functions

First, start the transmitter. Make sure that the motor speed joystick (see Figure 15, no. 10) is in the lowest position.
a) Adjusting the transmitter trim
Before proceeding with mechanical adjustments of the model, be sure to check the digital trim on the transmitter. This
is important because the trim setting is saved. The transmitter always resumes with the last trim values set before it
was switched off.
The digital trim is set using the trim buttons (see Figure 15, nos. 4, 5 and 6). In this model aircraft, the trim buttons with
position number 7 have no function. The complete trim range comprises approx. 20 individual steps in both directions
when viewed from the middle position. The two end positions and the middle position are signalled acoustically by a
longer beep.
Press all buttons one after the other and set the trim to the middle position. The transmitter beeps at every trim step.
Then connect the flight battery to the flight controller. The flight controller emits four beeps via the motor. The model
now responses to the remote control commands from the transmitter.
b) Checking the neutral position of the rudders
If you have already checked or readjusted the centre posi-
tion of the rudders when assembling the wings, the trailing
edges of the ailerons must form a line (1) with the trailing
edge of the wing.
If the ailerons are not accurately aligned, the wing must
be removed again and the ailerons must be adjusted as
shown in Figure 8.
The elevator linkage rod comes already prefabricated so
that no mechanical adjustment is required.
If the trailing edge of the elevator is not aligned with the
trailing edge of the tailplane, use the trim on the transmit-
ter to compensate for any deviation.
64
Figure 18
Figure 19