Inserting And Connecting The Drive Battery; Checking The Drive And Steering Functions - Reely Speedy Mania Bedienungsanleitung

e) Inserting and connecting the drive battery
• If you have not already done so, switch on the transmitter as described in section 9.
• Place the model boat on the included boat stand (it may still be disassembled and must be put together) so that
the propeller can turn freely and the movement of the rudder on the underside of the outboard motor dummy is
not hindered.
Warning!
Never reach into the propeller during or after connecting the LiPo drive battery. The drive could start up
unintentionally. The running propeller can cause severe injury!
• Open the hook and loop fastener (1) on the battery
holder.
• Insert the drive battery (2) so that its connection cable
(3) is on the same side as the speed controller cable.
• Fix the drive battery with the hook and loop fastener (1).
• Connect the rechargeable battery to the speed con-
troller. The connections are reverse polarity protected.
Place the connector on the edge of the hull so that it
cannot get into running parts of the drive.
• A green LED now lights up on the receiver.
• The motor emits 3 beeps. This means that the speed controller has recognised a 3-cell LiPo drive battery that has
been connected (the beeps are generated by briefly activating the motor).
• The motor then emits a low and a high beep, after which the model boat is ready for operation and responds to the
control commands from the transmitter.
If a red LED lights up on the receiver and no beeps are emitted, the receiver has not recognised a valid
transmitter signal. In this case, check whether the transmitter is switched on and ready for operation (trans-
mitter power LED glows steadily).
The receiver must be correctly connected to the transmitter so that it can respond to the radio signals.
Please refer to section 12.
f) Checking the drive and steering functions
After the transmitter has been switched on and the drive battery has been connected to the model boat, you can
check the drive and steering functions. You should always do this before putting the model boat on the water surface.
Warning!
When checking the drive and steering functions, the model boat must be positioned so that the propeller
can turn freely without hitting any obstacles. Furthermore, make sure that no parts of the body or hair can
get into the rotating propellers. The running propeller can cause severe injury!
You can easily perform short function tests of the drive without water cooling. However, do not let the drive
run at full throttle for a long time, otherwise the motor and the speed controller could overheat and be dam-
aged, which may result in a loss of warranty/guarantee!
Figure 6
45