Limitations On Use - Alpinestars Tech-Air 5 Plasma System Bedienungsanleitung

For safety issues and to ensure that the above factors have not reduced the integrity or
product performance levels, Alpinestars strongly recommends to refer to the System's
regular maintenance recommendations.
As written in this User Manual, always before any use, check the product for any damage to
any parts of the product. Regardless of the age of the product, do not use any product if
you notice any damage, cracking, deformity and/or the inside padding is deteriorating or if
the product no longer fits correctly or is lacking its structural integrity.
DISPOSAL
At the end of its life the product must be disposed of in accordance with local refuse
regulations. There are no hazardous materials used in the manufacture of the product.
ALLERGY ADVICE
Persons who have skin allergies to synthetic, rubber or plastic materials, should carefully
monitor their skin each time the product is used. In the event any irritation of the skin
occurs, immediately stop using the product, and seek medical advice.

LIMITATIONS ON USE

This product is for use ONLY while motorcycling and will ONLY provide limited protection
against impacts in the event of an accident or fall.
WARNING! Users should be aware that no product (including protector/s) will
provide complete protection against injury and no guarantees,
warranties (express or implied) are made regarding the product's
(including protector/s) ability to avoid risk injury.
WARNING! Users should be aware that different environmental conditions
including high or low temperatures can influence the characteristics
of the protector and may reduce the performance of the protector,
even if the T+ and/or T- are present in the pictogram.
Pyrotechnic Articles
The Tech-Air 5 PLASMA System contains one pyrotechnically activated cold Gas Inflator
®
and the whole item is considered as an "AIRBAG MODULE" Category P1 under EU Directive
2013/29. As such, a EU Type Examination (Module B) has been conducted on the design
of the System. An EU Type Examination and Audit (Module E) has been conducted on the
Manufacturing Site of the System.
The EU Type Examination and Audit have been conducted by Notified Body #0080, Ineris,
Parc Technologique ALATA BP2, Verneuil-en-Halatte, 60550, France.
The CE label on TechAir
pyrotechnic certification:
5 PLASMA System reports the relevant information regarding the
®
64 EN