Alpinestars Tech-Air 5 PLASMA System Bedienungsanleitung Seite 38

Before washing the Base Layer (1), it is necessary to remove the components of the System,
including the System's removable protectors, Airbag, Electronic Components and/or other
non-washable components of the System.
In order to clean the System, the User MUST follow the steps as described in the Section
below.
REMOVAL OF NON-WASHABLE COMPONENTS
Before washing, the User MUST first remove all of the non-washable components, which
include: the Back Protector (4), the Airbag (11) and ALL Electronic Components, including
the LED Display (3), and the Activation Zip (2). This operation can be performed following
the steps below:
1. Disconnect the LED Display (3) – First, place the System on a flat surface preferably on
top of a workbench or table, with the front of the System facing downwards. Access the
Back Protector (4) by opening the zip located on the back side of the System. Open the
cover with the Velcro closure on the Back Protector (4) and disconnect the LED Display (3)
Figure 1 (Showing how to active the system for the first time, showing shipping mode switch)
connector as indicated in Figure 23.
Figure 23: Disconnect the LED Display (3)
40 EN