Alpinestars Tech-Air 5 PLASMA System Bedienungsanleitung Seite 39

2. Detach the Back Protector (4) – Detach the Velcro on the upper part of the Back
Protector (4) and separate the Back Protector (4) from the Base Layer (1).
3. Detach the Airbag (11) - Through the rear opening, proceed to detach all 12 of the
connection loops that connect the Airbag (11) to the Base Layer (1) in the rear part of
the System and in the sleeves area. To access the connection loops on the front part of
the System use the two openings present on the sides of the inside of the garment, the
openings are located on the sides of the System directly underneath the armpit area, as
shown in Figure 24. Proceed by removing the Airbag (11) entirely from the Base Layer (1).
Openings
Figure 24: Base Layer (1) Openings
4. Remove the LED Display (3) and the Activation Zip (2) – Remove the LED Display (3) by
accessing the opening inside the garment, next remove the Activation Zip (2) located inside
the Velcro pocket as shown in Figure 25.
41 EN