Cleaning, Storage And Transportation; System Cleaning - Alpinestars Tech-Air 5 Plasma System Bedienungsanleitung

15. Cleaning, Storage and Transportation

15.1 System Cleaning

SYSTEM (FULLY ASSEMBLED)
After each use, it is recommended that any dirt and flies that may have accumulated on
the outer garment are removed by wiping down the garment with a damp cloth and drying
the garment afterwards using a towel. Do not use hot water or any other types of cleaners
or solvents on the System.
In the event the garment does get wet, allow it to dry naturally, do NOT attempt to wring
it out or place it in direct sunlight or next to any direct heat source with a temperature of
over 40°C.
BASE LAYER
The Base Layer (1) is defined as the Tech-Air
(such as Wiring, Sensors, LED Display, Electronic Control Unit etc...), Gas Inflators, Airbag
(11) and Protectors.
For proper care of the Base Layer (1), follow the instructions reported on the care warning
label below:
Hand wash 30°C/Do not bleach/Do not tumble dry/Do not iron/Do not dry clean
Base Layer (1) care warning label:
WARNING! Under NO circumstances should the System (BOTH fully assembled
and disassembled) be washed in a washing machine, tumble dried, or
ironed. This may cause permanent damage to the System and cause
malfunctioning of the System.
39 EN
System WITHOUT the Electronic Components
®