Alpinestars Tech-Air 5 PLASMA System Bedienungsanleitung Seite 19

WARNING! Always ensure that the Activation Zip (2) remains open and unzipped
when the System is not worn by the User; check the LED Display (3)
to verify that the System is not turned on or manually turn off the
System using the Display Button (3a) (see Section 6.3 "Turning off
the System.")
Once the Activation Zip (2) has been correctly closed, the System automatically turns on
and the User MUST
verifying that the following steps are performed:
1) LEDs Check: during this phase, the System will check if all the LEDs present on the LED
Display (3) are correctly functioning. The User will see that all the available LEDs (3b, 3c, 3d)
will turn on SOLID GREEN for approximately one second and then will turn off as shown in
Figure 9.
2) System Status Check: after the LEDs Check phase, the System Status LED (3b) will turn
SOLID BLUE indicating that the System is active (Figure 9) and therefore is ready to protect
the User in the event of an accident. A short vibration of approximately 1 second will also
be felt in the vicinity of the Activation Zip (2). In this condition, the User can also check
the existing Riding Mode (Riding Mode LED [3c]) that is currently running, and the battery
level of the System (Battery Level LED [3d]) (see Section 8; "LED Display (3) Indications
Summary.")
WARNING! If the System Status LED (3b) turns SOLID RED, a System Fault is
present (Figure 9). A long vibration of approximately 3 second will
also be felt in the vicinity of the Activation Zip (2). This condition
indicates that the System is NOT correctly functioning and, therefore,
is NOT ready to protect the User in the event of an accident (see
Section 19 "Troubleshooting.")
21 EN
first
check to make sure that the System is functioning correctly by