Alpinestars Tech-Air 5 PLASMA System Bedienungsanleitung Seite 40

Activation Zip
LED Display
Figure 25: Removal of the LED Display (3) and Activation Zip (2)
Now the Base Layer (1) is free from all the non-washable components and can be handwashed
at 30°C with gentle soap. The Base Layer (1) should NOT be washed with bleach, cleaners,
or chemical solvents, and it should NOT be dried in the dryer, nor ironed, nor dry cleaned
as reported in the instructions of the User Manual. To dry the Base Layer (1), ONLY use a
towel to pat down the garment or allow it to air dry naturally by hanging it up on a hangar
or placing it horizontally on a drying rack.
CLEAN THE NON-WASHABLE COMPONENTS
The User can now clean the remaining non-washable components ONLY by HAND-WIPING
them with a damp cloth and using water at a temperature of no higher than 30°C – DO
NOT submerge the non-washable parts in water. Under NO circumstances should the User
put the remaining non-washable components into a washing machine or a dryer. Under
NO circumstances should the User completely submerge all the remaining parts in water.
The User can ONLY submerge the textile parts (i.e. the Base Layer (1)) in water and soap
and cannot use any chemical solvents or cleaners to clean the System. ONLY use a damp
cloth with a small amount of gentle soap applied to the cloth to clean the non-washable
components and then dry the non-washable components afterwards using a towel or allow
them to air dry naturally.
42 EN