Troubleshooting - Alpinestars Tech-Air 5 Plasma System Bedienungsanleitung

18.4.2 Undeployed System
WARNING! An undeployed System still contains live pyrotechnic charges and
thus, must NOT be disposed of in household waste or incinerated.
An undeployed System must be returned to an Alpinestars' Tech-Air
return to Alpinestars who will handle the disposal. This service is free of charge.

19. Troubleshooting

Problem
LED Display (3) does not
switch on when Activation
Zip (2) is closed
SOLID YELLOW LED on the
LED Display (3)
SOLID RED LED on the LED
Display (3)
Blinking RED Battery Level
LED (3d)
53 EN
Possible Cause
System battery fully discharged
Activation Zip (2) not correctly
positioned
Airbag (11) must be replaced
Gas Inflator (9) empty
System Error
Battery Low
Dealer for subsequent
®
Possible Solutions
Recharge battery (see Section 7) and check the
light indication on the LED Display (3) during
the recharge. If the battery is very low, the
System may not activate the LED Display (3),
until a proper charge level has been reached.
Check the correct positioning of the Activation
Zip (2).
If the same Airbag (11) has reached the
maximum number of inflations guaranteed
for the System, the solid yellow LED will
appear on the LED Display (3) even after the
replacement of the Gas Inflator (9). In this
case, the Airbag (11) itself must be replaced
and the System reactivated by an Authorized
Tech-Air Service Center.
®
After the deployment, the Gas Inflator (9) must
be replaced. Until such replacing, the System
will not work even though the battery is
charged and the LED Display (3) will show the
red light until the Gas Inflator (9) is replaced.
If Gas Inflator (9) is not empty (double check
this using the Tech-Air App), The System may
®
have an internal error. Contact an Authorized
Alpinestars' Tech-Air Service Center to check
®
the System.
Remaining battery level is lower than 4 hours.
Recharge the battery as soon as possible as
reported in Section 7.