eta Duplica Vital plus Bedienungsanleitung Seite 54

GB
1-VITAL PLUS and 2-VITAL PLUS - table of programmed phases
Preparation phase
Time scope setting (min.)
Preset (min.)
Temperature scope setting (°C)
Preset (°C)
Crust colour setting
Preset
CYKLUS (CYCLE) button
The button is used for movement between each phase of the 1–VITAL PLUS and
2–VITAL PLUS. program setting.
LIST OF PROGRAMS
1. VITAL PLUS, 2. VITAL PLUS.
The program is used for individual setting of all phases for preparation of bread (e.g. of
gluten-free), challah, mincemeat, soya cheese and cultivation of cheese cultures.
The scope for time setting for each individual phase (i.e. PREHEAT / KNEAD 1, 2, 3 /
RISE 1, 2 / BAKE 1, 2 / KEEP WARM) is specified in the table of programme phases and
procedure for programming with the use of CYKLUS (CYCLE), ČAS (TIME) and BARVA
(COLOUR) buttons is described in section A, B, C and D.
The parameters are automatically save to memory bread maker for next use.
This program allows setting of time, temperature and colour and not the bread size.
A) For all PREHEAT / KNEAD 1,2,3 / RISE 1,2 / BAKE 1,2 / KEEP WARM, the procedure
for time programming is as follows:
- Press CYKLUS (CYCLE) button to display PREHEAT and time programmed for this work
OFF
cycle on the display (time data will be permanently displayed on the display).
- Press ČAS (TIME) button to setup the cycle duration (see table) or the phase may be
removed from the program, (time code flashes on the display).
- Press CYKLUS (CYCLE) button to move to the next phase of programming.
For programming of RISE 1, 2 phase, proceed according to section B.
For programming of BAKE 1, 2 phase, proceed according to section C.
For programming of KEEP WARM phase, proceed according to section D.
PREHEAT
0 - 30
0:05
-
-
-
-
-
-
-
-
/ 213
54
KNEAD 1 KNEAD 2
0 - 30 0 / 5 - 20
0:05 0:10
- -
- -
- -
- -
- -
- -
- -
- -