Switching On The Transmitter - Reely Mini-Wavebreaker Bedienungsanleitung

b) Switching on the transmitter
Check the correct power supply of the transmitter by put-
ting it into brief operation for test purposes.
To do this, slide the on/off switch (see also Figure 2, no.
4) from the left "OFF" position to the right "ON" position.
The LED indicator on the transmitter (see also Figure 2,
no. 2) starts to flash.
The LED indicator glows steadily when the
drive battery in the model boat is connected
and the model boat is put on the water surface.
To switch the transmitter off again, slide the on/off switch
back to the left switch position.
When the power supply is no longer sufficient for the
proper operation of the transmitter, the LED indicator (see
Figure 4, no. 2) starts to flash slowly.
In this case, immediately stop using the model boat and replace the 9 V block battery in the transmitter with a new
fresh one.
Figure 4
35