Switching On The Transmitter - Reely Wild Hawk 3.0 Bedienungsanleitung

c) Switching on the transmitter
Check the correct power supply of the transmitter by putting it into brief operation for test purposes.
Caution, important!
Before switching on the transmitter, always ensure that the motor speed and rudder joystick (see also Fig-
ure 13, no. 10) is in the lowest position since the flight controller and the motor are always activated when
the model is started.
Otherwise it may come to an activation of the programming mode on the flight controller. More information
about the programming mode can be found in section 14.
Then slide the on/off switch (see also Figure 13, no. 12)
from the lower "OFF" (switched off) position to the upper
"ON" (switched on) position.
The transmitter will emit a beep and the LED indicator (see
also Figure 13, no. 1) will light up briefly, then go out and
eventually glow a bit darker steadily.
To switch the transmitter off again, slide the on/off switch
back to the lower switch position.
When the power supply is not enough to ensure proper
operation of the transmitter, the transmitter emits a short
beep every 5 seconds. In this case, discontinue using the
model aircraft and replace the old batteries in the transmit-
ter with new fresh ones.
64
Figure 15