Switching On The Transmitter - Reely Wavebreaker 2.0 Bedienungsanleitung

b) Switching on the transmitter
Check the correct power supply of the transmitter by putting it into brief operation for test purposes.
To do this, slide the on/off switch (see also figure 2, no. 6)
from the left "OFF" position to the right "ON" position.
The green LED indicator for the operating voltage (see
also figure 2, no. 2) glows steadily and the red LED in-
dicator for the receiver linking (see also figure 2, no. 10)
flashes.
The red LED indicator for receiver linking on the
transmitter glows steadily when the receiver in
the model boat is switched on later.
To switch the transmitter off again, slide the on/off switch
back to the left switch position.
When the power supply is no longer sufficient for the
proper operation of the transmitter, the green LED indica-
tor (see figure 4, no. 2) starts to flash slowly.
In this case, immediately stop using the model boat and replace the battery set in the transmitter with a new fresh one.
Figure 4
37