Parameter List - Hitachi Abb Rvt Installation Und Betriebsanleitung

0x0805 Event Logging Settings
0x0806 Installation Settings 1
0x0807 User Settings
0x0808 ID
0x0809 Status information
5.4.1.4. Measurement
These are the different groups with their size, type and assigned group IDs:
Group ID Description
0x1000 Voltages
0x1001 Line Currents
0x1002 Temperature
0x1003 Powers
0x1005 PFC Control Data
0x1006 Status information
5.4.1.5. Universal
These are the different groups with their size, type and assigned group IDs:
Group ID Description
0x2001 Ethernet current settings
0x2081 LED control
5.5.

Parameter List

The parameter list is organized in several group of parameter.
Each group of parameter is identified by a Group ID.
A few data specifies how and where the data is available or can be programmed.
Parameters settings values have a limited range. If a written value exceeds the minimum and maximum allowable
values, the written group of parameter will be omitted.
1/ Byte offset
2/ Description
3/ Units
4/ RVT
5/ RVT3P
6/ Data type
7/ Size in bytes
8/ Default value
STATUS
Approved
140
12
31
57
9
Size (in bytes)
104
56
36
88
24
32
Size (in bytes)
20
1
Offset in bytes of the data into the Group of parameters
General description
Units depending of the type of data
Applicable for the RVT 6 or 12. Some data are not available
for the basic standard RVT
Applicable for the RVT 12 with 3 phase measurement. All
data are available into this full version of the RVT.
Format
Depending on the data type
Default value programmed as factory settings
SECURITY LEVEL
Public
43200
43300
43400
43500
32500
Modbus Base Address
30500
30600
30700
30800
30900
31000
Modbus Base Address
32600
31100
DOCUMENT ID
9AKK106713A9758
RVT CO MM UNI CATI O N
REV. LANG. PAGE
K en 25/71
© 2022 Hitachi Energy. All rights reserved.