Setting Up The Device With The Ecolab Pc Setup Program; Configuration And Parameters - ECOLAB Versatronic Betriebsanleitung

Fig. 115: Searching for devices on the local network
You can highlight the devices with the cursor (click on the line) and click OK to accept
them (or double-click the line). This enters the host name (DNS name) in the input field.
Fig. 116: Connection settings assistant
The "Check host name and switch" function selects IP address and copies it to the entry
field (you can edit it here, if required). Depending on the version, you can select the host
name or IP address from a drop-down list.
12.8

Setting up the device with the Ecolab PC Setup program

12.8.1

Configuration and parameters

All parameters of the configuration level and parameter level can be set either on the
device itself or with the Ecolab PC Setup program.
Ä Chapter 10.4 'Configuration' on page 143 and Ä Chapter 10.5 'Parameter setting'
See
on page 176.
207
PC setup program
417102269 Rev. 2-08.2020