Using The Controller - ECOLAB Versatronic Betriebsanleitung

USB è Device configuration:
A configuration stored on the memory stick is loaded into the device and activated as the
current configuration. Only the currently active configuration is overwritten.
The previous default configuration is maintained.
Service data è USB:
A record with service-related information of the device is transferred to the memory stick
and stored in a file named "DEBUG304.SET". The information can be used by Ecolab
service for diagnostic purposes.
Software update:
The device software can be updated using a USB memory stick.
A corresponding update file must be stored on the memory stick in advance that you can
obtain from Ecolab service.
CAUTION!
It is strongly recommended to perform a backup of the configuration and
recorder data before a software update.
9.4

Using the controller

Since the regulation of the automatic control operation is in the foreground,
it is very important to have the correct configuration of the respective
controller and its configuration (adjustment of the control response) to
achieve good process stability.
Therefore, make sure that all your settings are correct on the user level and
the parameter before operation of a controller channel.
See
The configuration is done automatically in most cases with the help of self-
optimisation. In exceptional cases, it may however be necessary to
determine control parameters experimentally or computationally and enter
them manually in the parameter sets of the controller.
The operation of the four different operating modes (automatic rule-mode, manual mode,
hold mode and self-optimisation) is shown in the following four sections.
Ä Chapter 10.3 'User level' on page 136.
93
Use
417102269 Rev. 2-08.2020